20170606
20170708
20170714
20170715
20170806
20170810
20170811
20170812
20170813
20170818
20170819
20170820
20170821
20170825
20170826
20170827
20170828
20170901
20170902
20170903
20170904
20170909
20170910
20170915
20170916
20170917
20170918
20170921
20170923
20170924
20170927
20170928
20170929
20171001
20171006
Hatseflats Design
Fitting Out Hatseflats
Sailing Hatseflats
Building TooPhat
|
<<
>>
20170910
|
- Cut the temporary moulds away from the bulkheads.
- Removed excess glue from the gunwales with a paint scraper.
- Cleaned up bow.
- Removed some of the copper wire stitching with a soldering iron (hard work).
- Cleaned up part of the bulkheads.
Found that the aft deck was too short: 70cm! Should have been 80cm.
Means that I must update the small parts design:
- aft deck 80x70 (instead of 70x70)
- daggerboard case 46cm height
- split 'bridge deck' into two halves
20170910_IMG_0197.JPG
20170910_IMG_0198.JPG
20170910_IMG_0200.JPG
20170910_IMG_0207.JPG
20170910_IMG_0208.JPG
|
|
